Fails!

During the process of making and printing stuff from our 3D printer, we made a lot of fails! Here is a list of them that my DAD did:

• While trying to hammer a piece into a rod, he cracked the piece.
• Deleted all the firmware on the circuit board.
• Cracked a foot of a Robot.
• And more I can't remember!

Now the mistakes I did:

• Dropped a Robot and his head came off.

Also we printed a cute little elephant and robot. We first had a few difficulties due to Slic3r. Then we fixed it by "correcting" the slicing code. After we did that, we started making a lot of them! I even gave one away!!!

Again, also the 3D printer failed today! One of the pieces that turns a gear to move the printer up and down, was STRETCHED!!! We don't know what happened but I'll keep you posted!

BTW: I will post photos of the FAILS later!!